Practices by Discipline

​Not applicable

​Not applicable

​Not applicable

​Not applicable

​Not applicable

​This Practice describes the minimum requirements to fabricate or install supports for large and small bore piping. The details provide dimensional and engineering requirements for the design of pipe supports. However, the suitability of all supports must be verified prior to use in any application. This practice is not a substitute for competent engineering analysis and design based on the specific requirements of each project.

This Practice covers minimum requirements for the maintenance of induction motors. The aspects of electrical maintenance are described. While many of the maintenance aspects covered in this Practice can be applied to synchronous and DC motor maintenance, synchronous and DC motor maintenance is not part of this Practice.

This Practice describes the requirements for the design, application, and extent of acoustic insulation on piping and equipment operating at high and low temperatures. Systems requiring additional insulation specifications beyond PIP Practices, such as ISO 15665, shall be covered by purchaser's documentation.Listing of or reference to supporting documents within this Practice does not imply suitability for specific designs.Comment Use of this Practice for contractual purposes requires the purchaser to make specific choices and assemble additional supporting documents.

This Practice provides installation details for hot insulation systems. This Practice provides details for installing hot insulation systems on piping, valves, horizontal and vertical vessels, and heat exchangers.

​This Practice describes the general requirements for surface preparation, application, and inspection of protective coatings.

​Not applicable

​Not applicable

​This Practice describes the general requirements for surface preparation, application, and inspection of architectural protective coatings utilized for substrates used in hygienic processes and facilities.

​Not applicable

This Practice provides recommended minimum and maximum flow rates for conventional centrifugal pumps (i.e., pumps with mechanical seals) to achieve safe operation while optimizing operating costs. This Practice describes how to use hydraulic and mechanical criteria to determine a recommended safe operating flow range for centrifugal pumps. This Practice does not provide hard limits for a pump's flow range because of factors that cannot be precisely defined.

​This Practice addresses lightning and static protection for facilities that process, manufacture, store, and handle flammable, non-flammable, combustible, and non-combustible products and materials. This practice will also address lightning and static protection of the electrical infrastructure used to support the manufacturing of these materials.

​Not applicable

​Not applicable

This Practice provides requirements for use by a Purchaser for determining the design criteria including design, materials of construction, inspection and testing for shell and plate heat exchangers constructed in accordance with ASME Boiler and Pressure Vessel Code, Section VIII, Division 1 or Division 2, henceforth referred to as the Code, and PIP VECV1001. Requirements that are specific to Code, Section VIII, Division 2 are shown in braces . This Practice provides requirements for purchasing shell and plate heat exchangers that are to be designed and fabricated by a Manufacturer. This Practice also provides guidance for the development of purchase specifications for the construction of new shell and plate heat exchangers which meet the philosophy and requirements of Code, Section VIII, Division 1 or 2 and PIP VECV1001.For some heat exchanger purchases, certain requirements in this Practice and in PIP VECV1001 may be assigned by Purchaser to Manufacturer. The specific requirements assigned (e.g., thermal design and the performance rating) can be specified on Purchaser's PIP VEDSP003 Data Sheet.

This Practice describes the mechanical design, fabrication, examination, inspection, testing, and documentation requirements for shell and plate heat exchangers constructed in accordance with ASME Boiler and Pressure Vessel Code, Section VIII, Division 1 or Division 2, henceforth referred to as the Code. Requirements that are specific to Code, Section VIII, Division 2 are shown in braces .This Practice is supplemental to the requirements of PIP VESV1002, Design and Fabrication Specification for Pressure Vessels, ASME Code Section VIII Divisions 1 and 2.